помогите определить по осмцилограмее уоз
- Автор темы induke
- Дата начала
очень редкая и малоизвестная инфа по этому вопросу
CRK disk:
The falling edge of the first tooth after the gap is 114 °CRK before the ignition TDC of the first
or the fourth cylinder.
CAM disk:
The electrical falling edge of the Intake CAM signal is positioned at tooth #114 (564°CRK
absolute), the electrical rising edge of the Intake CAM signal is located at tooth #54
(204°CRK abs.).
The distinction between tooth #1 and #61 is done depending on the Intake CAM signal level
during the gap:
- Intake CAM signal level = high during the gap, then tooth #61;
- Intake CAM signal level = low during the gap, then tooth #1.
The electrical falling edge of the Exhaust CAM signal is positioned at tooth #75 (336°CRK
abs.), the electrical rising edge of the Exhaust CAM signal is located at tooth #15 (696°CRK
abs.)
A "true power-on" logic of the CAM-Sensor is mandatory for this setup.
The firing order is stored as follows: 1 - 3 - 4 - 2 .
CRK disk:
The falling edge of the first tooth after the gap is 114 °CRK before the ignition TDC of the first
or the fourth cylinder.
CAM disk:
The electrical falling edge of the Intake CAM signal is positioned at tooth #114 (564°CRK
absolute), the electrical rising edge of the Intake CAM signal is located at tooth #54
(204°CRK abs.).
The distinction between tooth #1 and #61 is done depending on the Intake CAM signal level
during the gap:
- Intake CAM signal level = high during the gap, then tooth #61;
- Intake CAM signal level = low during the gap, then tooth #1.
The electrical falling edge of the Exhaust CAM signal is positioned at tooth #75 (336°CRK
abs.), the electrical rising edge of the Exhaust CAM signal is located at tooth #15 (696°CRK
abs.)
A "true power-on" logic of the CAM-Sensor is mandatory for this setup.
The firing order is stored as follows: 1 - 3 - 4 - 2 .